Reciprocating stroke: 0.7mm
Reciprocating frequency: 35000rpm
Air inlet size: 1/4"
Product model: DS 606S
Working air consumption: 0.08m3/min
Inlet pipe diameter: 5*8mm
1.This product does not contain oil stone and sickle
2.Accessories include oil stone chuck, file chuck, hex wrench, long air pipe, anti-slip sleeve
Aluminum alloy shell design
Use alloy steel blade motor
Low noise and low vibration. long life
Suitable for trimming, chamfering, mold polishing, etc.
Prevents the tool from slipping when grinding and hurts the sharp angle of the mold
1. Mold polishing, mirror processing
2. Die castings remove flash and trim the edges
Use pneumatic tools to suggest:
1. Inject 2-3c.c #60 pneumatic lubricant before and after daily use.
2. Please use free operation for a few seconds after oiling.
3. General transmission air compressor, the air compressor compresses out the moisture content of most of the gas, and the oil in the air compressor brought out by the air compressor piston. If the oil water separator is not used, the water and oil are gas. When entering the pneumatic tool, the wind blade will stick. If the tool moves together, the blade will not open. It may not start. If it can start, it will become insufficient torque. Be sure to inject the pneumatic oil from the rear air inlet and then press the pneumatic tool. After a few seconds of idling, the torque can return to normal.